Updated Cisco 352-001 Exam & 352-001 Real Exam Questions

CCDE, Cisco Comments Off

If you are searching for a one-stop solution for Cisco 352-001 exam, this Cisco 352-001 exam sample questions is only the answer you’re looking for. It’s proved that choosing Cisco 352-001 products and services is effective in reducing and save your Cisco 352-001 exam sample questions cost. An expert Cisco 352-001 certified online test might need only a small amount time as you require. Lead4pass’s the cause website of your own Cisco 352-001 examination preparation. You will be fully in a position to soak up your Cisco 352-001 test with our Cisco 352-001 dumps. Cisco 352-001 questions and answers for Cisco 352-001 certification exams from Lead4pass is the ultimate approach of obtaining success.

352-001 exam

QUESTION 70
A company has these requirements for access to their wireless and wired corporate LANs using 802.1x:
Client devices that are corporate assets and have been joined to the Active Directory domain are allowed access.

Personal devices must not be allowed access.

Clients and access servers must be mutually authenticated.
Which solution meets these requirements?
A. Protected Extensible Authentication Protocol/Microsoft Challenge Handshake Authentication Protocol Version 2 with user authentication
B. Extensible Authentication Protocol-Transport Layer Security with machine authentication
C. Extensible Authentication Protocol-Transport Layer Security with user authentication
D. Protected Extensible Authentication Protocol/Microsoft Challenge Handshake Authentication Protocol Version 2 with machine authentication

Correct Answer: B

352-001 exam
QUESTION 71
You are designing a wireless LAN with the following components:

High-density indoor access point deployment

2.4-GHz and 5-GHz radios

802.11a, 802.11g, and 802.11n mode wireless LAN clients
Site survey results show negligible foreign WiFi and non-WiFi interference. What is the best method to decrease duty cycle (radio frequency utilization) and increase overall wireless LAN client performance for this design?
A. Disable all data rates below 12 Mb/s on all access points.
B. Decrease radio transmit power on all access points that report a high duty cycle.
C. Increase radio transmit power on all access points that report a high duty cycle.
D. Disable all data rates above 12 Mb/s on all access points.
E. Increase radio transmit power on all access points.

Correct Answer: A
QUESTION 72
You are designing an optical network. Your goal is to ensure that your design contains the highest degree of resiliency. In which two ways will you leverage a wavelength-switched optical network solution in your network design? (Choose two.)
A. a wavelength-switched optical network assigns routing and wavelength information
B. a wavelength-switched optical network takes linear and nonlinear optical impairment calculation into account
C. a wavelength-switched optical network guarantees restoration based strictly on the shortest path available
D. a wavelength-switched optical network eliminates the need for dispersion compensating units in a network

Correct Answer: AB
QUESTION 73
You are the SAN designer for the ABC Company. Due to budget constraints, there is increased pressure by management to further optimize server utilization by implementing virtualization technologies on all servers and increase virtual machines density. Faced with some SAN challenges, the server team requests your help in the design and implementation of the SAN in the new virtualized environment.
In which two ways can NPIV be used in your proposed design? (Choose two.)
A. NPIV is used to assign multiple FCIDs to a single N Port.
B. NPIV is used to define and bind multiple virtual WWNs (VIs) to a single physical pWWN.
C. You recommend NPIV so that hosts can be members of different zones.
D. NPIV can be used to allow multiple applications on the same port to use different IDs in the same VSAN.

Correct Answer: AD
QUESTION 74
You are designing a network for a branch office. In order to improve convergence time, you are required to use the BFD feature. Which four routing protocols can you use to facilitate this? (Choose four.)
A. EIGRP
B. IS-IS
C. BGP
D. static
E. RIP
Correct Answer: ABCD
QUESTION 75
When developing an MVPN design, which performance and scalability consideration must be taken into account?
A. CE end-to-end PIM adjacency establishment
B. multicast data sent to all PE routers on the default MDT
C. RP placement in the multicast VRF
D. RP placement in the customer network
Correct Answer: B QUESTION 76
In order to meet your service level agreement, your network designer created a design solution that includes interface dampening. In which two ways will interface dampening benefit your overall network design? (Choose two.)
A. Interface dampening uses an exponential backoff algorithm to suppress event reporting to the upper-level protocols.
B. When the interface is dampened, further link events are not reported to the upper protocol modules.
C. When the interface is dampened, further link events are reported to the upper protocol module.
D. Periodic interface flapping that affects the routing system as a whole should have a period shorter than the system convergence time.

Correct Answer: AB
QUESTION 77
A company wants to use SSM as the multicast routing protocol inside its network. Some of its multicast applications do not support IGMPv3. In which two ways can the mapping be done when these applications send IGMPv2 join messages? (Choose two.)
A. The Layer 2 switches can send a request to a DNS server.
B. The Layer 3 multicast routers can send a request to a DNS server.
C. The mapping can be done statically at the Layer 2 switches.
D. The mapping can be done statically at the Layer 3 multicast routers.
E. The Layer 2 switches can transform the IGMPv2 join to an IGMPv3lite join.
F. The Layer 3 multicast routers can transform the IGMPv2 join to an IGMPv3lite join.

Correct Answer: BD
QUESTION 78
A company plans to use BFD between its routers to detect a connectivity problem inside the switched network. An IPS is transparently installed between the switches. Which packets should the IPS forward for BFD to work under all circumstances?
A. IP packets with broadcast IP source addresses
B. IP packets with identical source and destination IP addresses
C. fragmented packets with the do-not-fragment bit set
D. IP packets with the multicast IP source address
E. IP packets with the multicast IP destination address
F. IP packets with the destination IP address 0.0.0.0

Correct Answer: B
QUESTION 79
What is a design aspect regarding multicast transport for MPLS Layer 3 VPNs using the Rosen Draft implementation?
A. LDP is the multicast control plane protocol.
B. Multicast traffic is forwarded over GRE tunnels.
C. Multicast traffic is forwarded over LDP or RSVP signaled LSPs.
D. Using the MDT SAFI in BGP ensures that PIM can be disabled in the core.

Correct Answer: B
QUESTION 80
A network designer wants to improve a company network design due to multiple network crashes. Which technology would allow for the restore of a network connection without informing the Layer 3 protocol?
A. Bidirectional Forwarding Detection
B. automatic protection switching
C. UniDirectional Link Detection
D. Ethernet OAM

Correct Answer: B
QUESTION 81
ACME Corporation is integrating IPv6 into their network, which relies heavily on multicast distribution of data. Which two IPv6 integration technologies support IPv6 multicast? (Choose two.)
A. 6VPE
B. 6PE
C. dual stack
D. ISATAP
E. 6to4
F. IPv6INIP

Correct Answer: CF  https://www.itcertlab.com/cisco-352-001-pdf.html
QUESTION 82
Network designers plan to interconnect two geographically separated data centers using an Ethernet-over-MPLS pseudowire. Within that design, the link between the sites is stable, there are no apparent loops in the topology, and the root bridges for the respective VLANs are stable and unchanging. What additional aspect of the design should be adjusted to mitigate the chance of connectivity issues to the peer data center when the connection takes place?
A. Enable 802.1d on one data center, and 802.1w on the other.
B. Ensure that the spanning tree diameter for one or more VLANs is not too large.
C. Enable UDLD on the link between the data centers.
D. Enable root guard on the link between the data centers.
Correct Answer: B
QUESTION 83
You are the lead IP/MPLS network designer of a service provider called XYZ. You are leading a design discussion regarding IPv6 implementation in the XYZ

Preparing Cisco 352-001 pdf is not difficult now. You can prepare from Cisco 352-001 Books or Cisco 352-001 dumps. Here we have mentioned some sample questions. You can use our free Cisco 352-001 study material notes for test preparation. Latest Cisco 352-001 vce available.

For More Details : https://www.itcertlab.com/cisco-352-001-pdf.html

Article Link: http://www.microsoft-technet.com/cisco-200-105-pdf-with-quick-learning-exam-samples.html

Read More: http://www.exampass.net/download-latest-cisco-210-260-dumps.html

 

Author

Back to Top